Manufacturers say that installing a couple of 300-watt panels will give a saving of up to 30% on a typical household’s electricity bill. With an outlay of €400-800 and with no installation cost, the panels could pay for themselves within six years.

In Spain, where two thirds of the population live in apartments and installing panels on the roof requires the consent of a majority of the building’s residents, this DIY technology has obvious advantages.

With solar balconies, no such consent is required unless the facade is listed as of historic interest or there is a specific prohibition from the residents’ association or the local authority. Furthermore, as long as the installation does not exceed 800 watts it doesn’t require certification, which can cost from €100 to €400, depending on the area.


As with all solar power systems, balcony power only works in daylight and a battery storage system can add at least €1,000 to the installation cost.


Vernetta says the vertical surface area of cities is far greater than that of the roofs and that, in Spain, balcony panels benefit more than roof panels from the low winter sun.

Cities such as Helsinki are already experimenting with buildings with solar panel cladding.

  • jagged_circle@feddit.nl
    link
    fedilink
    English
    arrow-up
    5
    ·
    6 hours ago

    Belgium, which outlawed plug-in solar devices over fears of having unregistered systems feeding into the grid, will lift its ban.

    Why the fuck is that a fear?!?

    • JohnEdwa@sopuli.xyz
      link
      fedilink
      arrow-up
      3
      ·
      edit-2
      4 hours ago

      And in addition to them backfeeding into the grid , they bypass all the fuses and GFCI protections your house might have and effectively require the use of a suicide cord. That part of a plug should never be providing power, only using it.

    • invertedspear@lemm.ee
      link
      fedilink
      arrow-up
      8
      ·
      6 hours ago

      Because back feeding the grid means the power company can’t shut the power down to work on a line. It requires coordinating everyone that might have something like this to unplug it. Rooftop installations add controllers to only supply when grid power is on, or to disconnect the house from the grid. Same thing when you add a generator inlet you’re supposed to also add a grid disconnect.

        • unyons@feddit.org
          link
          fedilink
          English
          arrow-up
          3
          ·
          52 minutes ago

          I live in Germany, and I can assure you no such check exists. I have one of these systems (although I don’t plug mine into the grid, I store power in batteries and use it)

          I’m not sure how the electricians protect themselves, I can only assume that they measure for voltage on the line after disconnecting from the grid, and then search for the culprits. Generally speaking any service providers inform residents well beforehand about outages, and there might be fines if you hold back work? I haven’t looked into it, perhaps someone else has more info.

    • sanzky@beehaw.org
      link
      fedilink
      arrow-up
      5
      ·
      edit-2
      3 hours ago

      it’s for the safety of people working on the grid. solar panels in general have either to be isolated from the grid or disconnect if the grid is down. they are not allowed to spill into the grid if the grid has no power.